There is nothing like the experience of flying an FPV drone, but building these marvelous machines is more complex than it needs to be. With Tramp, we set out to raise the bar on video transmitter technology. With Ghost, we set out to redefine the norms in receivers for R/C control. And now we have fused these two together, in the groundbreaking Ghost Hybrid. Designed by pilots, built by pilots, supported by pilots.

Features

20 x 20mm Mounting
Single-sided PCB with gummies included
Only 2.2g, perfect for the sub-250g class
Long-range AND low latency
250Hz updates
2.4GHz LoRa and FLRC Control
5.8GHz 1-600mW Video Transmitter
All 48 Standard Channels
Thermally regulated, Factory calibrated
500Hz/1kHz ready for when OpenTx can supply quality data at this rate
Available vTx channels and power may vary from region to region to comply with local regulations
2.4GHz ISM Band
Tiny 15 x 12mm, and 0.61g
Two fully independent Ghost receivers
Crazy Race Performance, 222.22Hz updates (500Hz Ready)
4ms End to End Latency (2ms ready), with OpenTx Integration
Fully supported by Betaflight with GHST driver

INTELLIGENT VTX CONTROL

Intelligent, and direct control of the video transmitter from the Ghost ecosystem. Use either the OLED menus on the Ghost Transmitter module or the responsive OpenTx tools menu. Tx remains silent on power-up, shuts down immediately in an (unlikely) failsafe.

LOCKING CONNECTORS

Innovative locking connectors deliver the advantages of the light-weight u.FL/MHF standard, with the security required for world-class racing, or long-range flying. Simply plug the connector onto the board, and slide the locking cap to secure.

THERMAL REGULATION + CALIBRATION

As with all tramp products, the Hybrid includes automatic thermal regulations, protecting the video transmitter against potentially damaging overheating while sitting on the starting pad. The on-board Tramp is factory calibrated, for precise power delivery during critical race events.

qTee ANTENNAS

qTee, a.k.a ‘Cutie’ antennas are center-fed dipoles, with integral balun to ensure no cable radiation, and without unexpected nulls in the radiation pattern. Tip to Tip length of just 60mm, easy to install in anything from a Whoop™ to an X-Class quad

Specifications

Downlink RF Power: +13dBm
Sensitivity: -117dBm in Long Range mode
Serial Formats: GHST, SBus, SBus-Fast (200k), SRXL-2 (400k), SBus Inverted
Firmware: Over-the-air (OTA) upgradeable (Rx and VTx)
Power Supply: 5V, with Over Voltage Protection
VTX Control: Automatic, via Ghost
Antenna Connectors: Standard U.FL with Locking Connectors
Dimensions: 26mm x 126mm, 2.2g (w/o antennas)

Manual

Firmware/ Downloads

Includes

1x Immersion RC Ghost Hybrid 5.8GHz vTx/2.4GHz Rx
2x qTee Antenna
1x Silicone Cables
1x Heat Shrink

Prices for ImmersionRC Ghost Hybrid 5.8GHz VTX / 2.4GHz Rx in stores

Deals found: 1 (NewBeeDrone¹)

Store	Stock level	Lot price	Shipping cost	Coupon / promocode	Pcs./lot	1pc price
NewBeeDrone	Stock level: 18	$50			1	$50

Long Range Systems LRS